Print from SD Card

print from SD .jpg

1

Import the .stl format model files in our slicing software (Mankati UM), and output the Gcode files in the SD card.

Note: It is better to use the default settings for the first run.

Insert the SD card into Mankati Fullscale XT Plus.

2

Insert the SD card into Mankati Fullscale XT Plus.

Choose “Print from SD card”, then select your Gcode file.

3

Choose “Print from SD card”, then select your Gcode file.

Use shovel to take it out gently

4

When your printing finished, the build plate will move down and be heated to 50℃ automatically for taking your model off more easily.
Use shovel to take it out gently to avoid the damage of the heat bed glass and your model.

 

Note: If the model is difficult to be off, you can raise the build plate temperature to 60. Too much power pulling the model will cause damage to the glass surface! This kind of damage during use is NOT covered by the warranty of “free parts replacement service”. Please do the removing carefully!!  
Warning: Do not touch the nozzle while it is totally cooled down. Wait until the actual temperature on LCD is lower than 30 degrees.