Install the Build Plate
Turn on your Fullscale XT Plus, enter “Prepare > Move axis > Move 1mm> Move Z”, lower Z axis a little(e.g., 30mm) to avoid collision of nozzle and build plate during installation.
Insert the build plate’s holder into the middle of plate.
Note: The wire connection side should be put toward your machine.
Take out the nuts⑥and screwdriver from the tool box to fix the platform firmly.
After installing the plate, please tighten the 4 screws under it properly to lower it and avoid knocking the extruders in the plate leveling operation.
Note: Do not screw the screws too tight! Or your build plate glass maybe cracked.
Connect the power wire and data cable of platform with the connectors.
Caution: Make sure the connection fully. Otherwise, it can cause the platform heating problems or connectors over-heated.
Install the Filament Feeder
Feeding motor: using the small spanner to install No. 1 feeding motor on position 1.
Insert the end of feeding tube into the socket of feeding motor and tighten it firmly.
Connect the data cable to the feeding devices
Feeding device installation done.
Install the Filament Spool Holder
Take the two spool holders out of the tool box.
Install filament spool’s holder.
Fullscale XT Plus Outlook
1. SD-card slot
2. Push and rotate knob
3. LCD screen
4. Build plate screws
5. Build plate
6. Print head
7. Filament guide tube
8. Printer holder
9. Power switch button
10. Power Socket
11. Machine label
12. Spool holder
13. Feeder motor
14. USB Socket