Stick the Kapton Tape

Clean the heat bed glass
Stick the kapton tape onto the heat bed

1

Clean the heat bed glass carefully to ensure it’s clean and tidy. About 3 lines of tape is needed to cover the glass completely.

Take the tape out(15). If covering the plate completely, it will need 3 lines of the tape.

Stick the kapton tape onto the heat bed.
It is a kind of high temperature resistance doubleside tape.

Uncover one side of the tape to stick it on the plate

2

Uncover one side of the tape to stick it on the plate. Please ensure the tape is smooth enough without any bubbles.

use the yellow shovel in tool box to push and press it while sticking

3

You can use the yellow shovel in tool box to push and press it while sticking.

Cut the tape off along the edge of the heat bed glass.

4

Cut the tape off along the edge of the heat bed glass.

Cut off the parts on the screws

5

Cut off the parts on the screws when sticking the third line. If some big bubbles appear, just use a needle to stick into them. Then smooth them with yellow board.

uncover the other side of the tape
stick kapton tape done

6

After sticking the tape on the plate, please uncover the other side of the tape.

Note: After several printing, the stickiness is not strong enough, please change the tape.